ゲートウェイ Cisco 2600 SeriesのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco 2600 Series 22 ページ。 Configuring adsl wic to support pppoe clients
Cisco 2600 Series にも: インストレーション・マニュアル (12 ページ), リリースノート (32 ページ), 構成 (15 ページ), アプリケーションノート (41 ページ), データシート (6 ページ), 付録 (15 ページ), 概要 (13 ページ), クイック・スタート・マニュアル (2 ページ), マニュアル (5 ページ)

Cisco 2600 Series インストレーション・マニュアル

Installing the Router

This chapter guides you through the installation of the Cisco 2600 series routers and includes the
following sections:
Required Tools and Equipment, page 3-1
Only trained and qualified personnel should be allowed to install or replace this equipment. To see
Warning
translations of the warnings that appear in this publication, refer to the Regulatory Compliance
and Safety Information document that accompanied this device.

Required Tools and Equipment

Installation might require some tools and equipment that are not provided as standard equipment with
the router. Following are the tools and parts required for a typical router installation:
Number 2 Phillips screwdriver.
Flat-blade screwdrivers: small, 3/16-in. (0.476 cm) and medium, 1/4-in. (0.625 cm).
Electrostatic discharge (ESD)-preventive wrist strap.
Screws to secure the rack-mount brackets to the router.
Grounding lug with attaching screws.
Cables for connecting a PC or modem to the router (included).
Cables for connection to the WAN and LAN ports (dependent on configuration):
OL-2171-02
Ethernet 10BASE-T cable for connection to an Ethernet port (included).
-
-
Ethernet 100BASE-T cable for connection to a Fast Ethernet port (included).
Token Ring lobe cable for connection to the Token Ring port (included).
-
C H A P T E R
Cisco 2600 Series Routers Hardware Installation Guide
3
3-1