Connecting to the Network
Connecting to an Ethernet Network
You can connect the Cisco AS5400XM universal gateway to an Ethernet network by using a
straight-through RJ-45-to-RJ-45 Ethernet cable to connect the Gigabit Ethernet port to an Ethernet hub.
(See
To comply with the intra-building lightning surge requirements of GR-1089-CORE, Issue III, October
Caution
2002, you must use a shielded cable when connecting to either of the Cisco AS5400XM universal
gateway Ethernet ports. The cable must consist of shielded cable terminated by shielded connectors on
both ends, with the cable shield material tied to both connectors.
Figure 3-6
1
2
3
Connecting to a WAN
The telecommunications lines must be disconnected 1) before unplugging the main power connector
Warning
and/or 2) while the housing is open. Statement 89
Hazardous network voltages are present in WAN ports regardless of whether power to the router is
Warning
OFF or ON. To avoid electric shock, use caution when working near WAN ports. When detaching
cables, detach the end away from the router first. Statement 77
Warning
This equipment is to be installed and maintained by service personnel only as defined by AS/NZS 3260
Clause 1.2.14.3 Service Personnel. Statement 88
Cisco AS5400XM Universal Gateway Chassis Installation Guide
3-6
Figure
3-6.)
Connecting to an Ethernet Hub (10/100BASE-T Shown)
1
3
GE1 10/100/1000BASE-T port
Ethernet hub
Straight-through Ethernet cable
Chapter 3
Installing the Cisco AS5400XM Universal Gateway
8
7
1
2
OL-6418-02