- ページ 5

ゲートウェイ Cisco Catalyst 8200 SeriesのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco Catalyst 8200 Series 8 ページ。 Installing andupgrading field replaceableunits

ページを印刷する

Cisco Catalyst 8200 Series クイック・スタート・マニュアル

Installing and Upgrading Field Replaceable Units

These are the steps to install a DIMM:

1. Remove the chassis cover.

2. Locate the DIMM slot on thedevice. There are two DIMM slots in the chassis and you can install the

DIMM module on either of the slots.

3. Make sure that both latches on the DIMM connector are in the open position.

4. Orient the DIMM so that the polarization notch lines up with the polarization key on the connector.

5. Insert the DIMM into the connector.

6. Replace the chassis cover.

Removing a DIMM

These are the steps to remove a DIMM:

1. Remove the chassis cover.

2. Locate the DIMM module on the device. Refer to the

DIMM module.

3. Pull the latches away from the DIMM at both ends to lift the DIMM slightly. Pull the DIMM out of the

socket.

Chassis-Internal

section to identify and locate the

Installing and Upgrading Field Replaceable Units

Removing a DIMM