ゲートウェイ Cisco Catalyst 8200 SeriesのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco Catalyst 8200 Series 8 ページ。 Installing andupgrading field replaceableunits
ページを印刷する
Installing and Upgrading Field Replaceable Units
•
•
•
•
•
•
•
•
Install and Remove Small Factor Pluggable
Laser Safety Guidelines
Optical Small-Form Pluggable (SFPs) use a small laser to generate the fiber-optic signal. Keep the optical
transmit and receive ports covered whenever a cable is not connected to the port.
Warning
Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into beams or
view directly with optical instruments. Statement 1051
Warning
Ultimate disposal of this product should be handled according to all national laws and regulations. Statement
1040
Warning
Pluggable optical modules comply with IEC 60825-1 Ed. 3 and 21 CFR 1040.10 and 1040.11 with or without
exception for conformance with IEC 60825-1 Ed. 3 as described in Laser Notice No. 56, dated May 8, 2019.
Statement 1255.
To install an SFP module in your device, perform these steps:
Install and Remove Small Factor Pluggable, on page 1
Removing and Replacing the Chassis Cover, on page 3
Installing a DIMM, on page 4
Removing a DIMM, on page 5
Installing the M.2 Storage Module, on page 6
Installing and Removing a NIM , on page 7
Installing Pluggable Interface Module, on page 8
Installing Drive Bays, on page 8
Installing and Upgrading Field Replaceable Units
1