Cisco Catalyst 8200 Series 빠른 시작 매뉴얼

{카테고리_이름} Cisco Catalyst 8200 Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Catalyst 8200 Series 8 페이지. Installing andupgrading field replaceableunits

페이지 인쇄

Installing and Upgrading Field Replaceable Units

•

Install and Remove Small Factor Pluggable

Laser Safety Guidelines

Optical Small-Form Pluggable (SFPs) use a small laser to generate the fiber-optic signal. Keep the optical

transmit and receive ports covered whenever a cable is not connected to the port.

Warning

Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into beams or

view directly with optical instruments. Statement 1051

Warning

Ultimate disposal of this product should be handled according to all national laws and regulations. Statement

1040

Warning

Pluggable optical modules comply with IEC 60825-1 Ed. 3 and 21 CFR 1040.10 and 1040.11 with or without

exception for conformance with IEC 60825-1 Ed. 3 as described in Laser Notice No. 56, dated May 8, 2019.

Statement 1255.

To install an SFP module in your device, perform these steps:

Install and Remove Small Factor Pluggable, on page 1

Removing and Replacing the Chassis Cover, on page 3

Installing a DIMM, on page 4

Removing a DIMM, on page 5

Installing the M.2 Storage Module, on page 6

Installing and Removing a NIM , on page 7

Installing Pluggable Interface Module, on page 8

Installing Drive Bays, on page 8

Installing and Upgrading Field Replaceable Units