Cisco Catalyst 8200 Series 빠른 시작 매뉴얼 - 페이지 8

{카테고리_이름} Cisco Catalyst 8200 Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Catalyst 8200 Series 8 페이지. Installing andupgrading field replaceableunits

페이지 인쇄

Installing Pluggable Interface Module

All module slots must have a module or blank installed for the product to work thermally and for safety

purposes.

Installing Pluggable Interface Module

To insert the PIM into the router, do these steps:

1. Insert and then gently push the PIM into the pluggable slot until firmly fixed.

2. Tighten the screw.

Installing Drive Bays

If you have not ordered drives, the drive bay slot is closed with a blank cover.

These are the steps to install a drive in a drive bay:

1. The drive bay is in the front panel of the device. The bay is closed with a cover if there are no drives in

the slots.

2. Press the push button on the center of the cover and pull the cover out of the system to expose the slot.

3. Slide the drive into the slot.

Note

Keep the drive bays covered when there are no drives installed in the slot.

Installing and Upgrading Field Replaceable Units

Securing screw

Installing and Upgrading Field Replaceable Units

PIM Module