- ページ 32

ゲートウェイ Cisco DPC3848VのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Cisco DPC3848V 50 ページ。 Wi-fi home gateway
Cisco DPC3848V にも：クイック・インストール・マニュアル (2 ページ)

Chapter 2 Installing the D OC SIS 3.0 W ireless Residential Gateway

Connect the Wireless Residential Gateway

The following installation procedure ensures proper setup and configuration for the

residential gateway.

Choose an appropriate and safe location to install the residential gateway (close

to a power source, an active cable connection, your PC-if using high-speed

Internet, and your telephone lines-if using VoIP). For assistance, refer to Where Is

the Best Location for My Wireless Residential Gateway? (on page 11). For a

MoCA installation, also see Recommended MoCA Installation Guidelines (on

page 18).

Power off your PC and other networking device; then, unplug them from the

power source.

Connect the active RF coaxial cable from your service provider to the coax

connector labeled CABLE on the back of the residential gateway.

Note: To connect a TV, DHCT, set-top, or VCR from the same cable connection,

you will need to install a cable signal splitter (not included). Always check with

your service provider before using a splitter as a splitter may degrade the signal.

For more information about a MoCA installation, see MoCA Installation

Guidelines (on page 18).

Connect your PC to the residential gateway using one of the following methods:



Ethernet Connection. Connect one end of an Ethernet cable to the Ethernet

port on your PC, and connect the other end to the Ethernet port on the back

of the residential gateway.



Wireless Connection. Make sure that your wireless device is powered up.

You will need to associate your wireless device with the residential gateway

once the residential gateway is operational. Follow the directions provided

with your wireless device for associating with a wireless access point. Make

sure that either the 2.4G or the 5G indicator is ON.

WARNING:



To avoid personal injury, follow the installation instructions in the exact

order shown.



Wiring and connections must be properly insulated to prevent electrical

shock.



Disconnect power from the residential gateway before attempting to

connect to any device.

OL-30544-01