- ページ 37

ゲートウェイ Cisco VG202のPDF ハードウェア・インストール・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco VG202 50 ページ。 Voice gateways
Cisco VG202 にも：ソフトウェア設定マニュアル (50 ページ), マニュアル (10 ページ), ハードウェア・インストール・マニュアル (48 ページ), クイック・スタート・マニュアル (19 ページ)

Chapter 3

Installing Cisco VG202 and Cisco VG204 Voice Gateways

Figure 3-5

Connect the other end of the ground wire to a grounding point at your site.

Step 5

Connecting Cables

This section provides the procedures for connecting cables to your voice gateway.

Warning

Do not work on the system or connect or disconnect cables during periods of lightning activity.

Statement 1001

Warning

Take care when connecting units to the supply circuit so that wiring is not overloaded. Statement 1018

This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that

Warning

the protective device is rated not greater than:

120 VAC, 15A (240 VAC, 10A international) Statement 1005

To prevent accidental discharge in the event of a power line cross, route on-premise wiring away

Warning

from power cables and off-premise wiring, or use a grounded shield to separate the on-premise

wiring from the power cables and off-premise wiring. A power line cross is an event, such as a

lightning strike, that causes a power surge. Off-premise wiring is designed to withstand power line

crosses. On-premise wiring is protected from power line crosses by a device that provides

overcurrent and overvoltage protection. Nevertheless, if the on-premise wiring is in close proximity

to, or not shielded from, the off-premise wiring or power cables during a lightning strike or power

surge, the on-premise wiring can carry a dangerous discharge to the attached interface, equipment,

and nearby personnel. Statement 338

OL-15959-01

Chassis Ground Connection Using Ring Terminal

V G 2 0 4

Fa st Et he rn

CO NS O LE

FX S

0/ 1

0/ 0

AU X

0/ 3

0/ 2

0/ 1

0/ 0

Ring terminal attachment

Cisco VG202 and Cisco VG204 Voice Gateways Hardware Installation Guide

12 V D C

S A

3-9