- ページ 39

ゲートウェイ Cisco VG202のPDF ハードウェア・インストール・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco VG202 50 ページ。 Voice gateways
Cisco VG202 にも：ソフトウェア設定マニュアル (50 ページ), マニュアル (10 ページ), ハードウェア・インストール・マニュアル (48 ページ), クイック・スタート・マニュアル (19 ページ)

Chapter 3

Installing Cisco VG202 and Cisco VG204 Voice Gateways

To connect a terminal or PC to the console port on the voice gateway and access the CLI, follow these

steps:

Connect the RJ-45 end of a DB-9–to–RJ-45 serial cable to the RJ-45 Console Aux port on the voice

Step 1

gateway.

voice gateway.

Figure 3-7

Connect the DB-9 end of the RJ-45–to–DB-9 serial cable to the to the COM port on your laptop or PC.

Step 2

Note

To communicate with the voice gateway, begin a terminal emulator application.

Step 3

Connecting an FXS line

Use a standard straight-through RJ-11 modular telephone cable to connect a Foreign Exchange Service

(FXS) port to a telephone or fax machine.

This equipment contains a ring signal generator (ringer), which is a source of hazardous voltage. Do

Warning

not touch the RJ-11 (phone) port wires (conductors), the conductors of a cable connected to the RJ-11

port, or the associated circuit-board when the ringer is active. The ringer is activated by an incoming

call.

OL-15959-01

Figure 3-7

shows the RJ-45 end of the serial cable connected to the Console Aux port on the

Connecting a Terminal or PC to the Console Port

VG 20 4

Fa stE the rne

CO NS OL E

FX S

0/1

0/0

AU X

0/3

0/2

0/1

0/0

RJ-45 connector to the Console Aux port on

the voice gateway

Some laptops and personal computers do not have DB-9 serial port connectors and may require

a USB–to–serial port adapter.

Cisco VG202 and Cisco VG204 Voice Gateways Hardware Installation Guide

12 V DC

DB-9 connector

Connecting Cables

3-11