Cisco VG202 하드웨어 설치 매뉴얼 - 페이지 39
{카테고리_이름} Cisco VG202에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco VG202 50 페이지. Voice gateways
Cisco VG202에 대해서도 마찬가지입니다: 소프트웨어 구성 매뉴얼 (50 페이지), 매뉴얼 (10 페이지), 하드웨어 설치 매뉴얼 (48 페이지), 빠른 시작 매뉴얼 (19 페이지)
페이지 인쇄
Chapter 3
Installing Cisco VG202 and Cisco VG204 Voice Gateways
To connect a terminal or PC to the console port on the voice gateway and access the CLI, follow these
steps:
Connect the RJ-45 end of a DB-9–to–RJ-45 serial cable to the RJ-45 Console Aux port on the voice
Step 1
gateway.
voice gateway.
Figure 3-7
1
Connect the DB-9 end of the RJ-45–to–DB-9 serial cable to the to the COM port on your laptop or PC.
Step 2
Note
To communicate with the voice gateway, begin a terminal emulator application.
Step 3
Connecting an FXS line
Use a standard straight-through RJ-11 modular telephone cable to connect a Foreign Exchange Service
(FXS) port to a telephone or fax machine.
This equipment contains a ring signal generator (ringer), which is a source of hazardous voltage. Do
Warning
not touch the RJ-11 (phone) port wires (conductors), the conductors of a cable connected to the RJ-11
port, or the associated circuit-board when the ringer is active. The ringer is activated by an incoming
call.
OL-15959-01
Figure 3-7
shows the RJ-45 end of the serial cable connected to the Console Aux port on the
Connecting a Terminal or PC to the Console Port
VG 20 4
Fa stE the rne
t
CO NS OL E
FX S
0/1
0/0
AU X
0/3
0/2
0/1
0/0
1
RJ-45 connector to the Console Aux port on
the voice gateway
Some laptops and personal computers do not have DB-9 serial port connectors and may require
a USB–to–serial port adapter.
Cisco VG202 and Cisco VG204 Voice Gateways Hardware Installation Guide
12 V DC
SA
2
2
DB-9 connector
Connecting Cables
3-11