- ページ 45

ゲートウェイ Cisco VG202のPDF ハードウェア・インストール・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco VG202 50 ページ。 Voice gateways
Cisco VG202 にも： ソフトウェア設定マニュアル (50 ページ), マニュアル (10 ページ), ハードウェア・インストール・マニュアル (48 ページ), クイック・スタート・マニュアル (19 ページ)

ページを印刷する
Cisco VG202 ハードウェア・インストール・マニュアル
Chapter 4
Powering On the Cisco VG202 and Cisco VG204 Voice Gateways
Enter the virtual terminal password, which prevents unauthenticated access to the voice gateway through
Step 8
ports other than the console port:
The virtual terminal password is used to protect
access to the voice gateway over a network interface.
Enter virtual terminal password: xxxxxx
Step 9
Respond to the following prompt as appropriate for your network:
Configure SNMP Network Management? [yes]:
Community string [public]:
A summary of the available interfaces is displayed.
Choose one of the available interfaces for connecting the voice gateway to the management network:
Step 10
Enter interface name used to connect to the
management network from the above interface summary: fastethernet4
Respond to the following prompts as appropriate for your network:
Step 11
Configuring interface FastEthernet0/0:
Use the 100 Base-TX (RJ-45) connector? [yes]: yes
Operate in full-duplex mode? [no]: yes
Configure IP on this interface? [yes]: yes
IP address for this interface: 172.1.2.3
Subnet mask for this interface [255.255.0.0] : 255.255.0.0
Class B network is 172.1.0.0, 26 subnet bits; mask is /16
The configuration is displayed:
The following configuration command script was created:
hostname VG
enable secret 5 $1$D5P6$PYx41/lQIASK.HcSbfO5q1
enable password xxxxxx
line vty 0 4
password xxxxxx
snmp-server community public
!
no ip routing
!
interface FastEthernet0/0
no shutdown
speed 100
duplex auto
ip address 172.1.2.3 255.255.0.0
!
Step 12
Respond to the following prompts. Enter 2 to save the initial configuration.
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
Enter your selection [2]: 2
Building configuration...
Use the enabled mode 'configure' command to modify this configuration.
Press RETURN to get started! RETURN
The user prompt is displayed.
VG>
OL-15959-01
Cisco VG202 and Cisco VG204 Voice Gateways Hardware Installation Guide
Initial Configuration Procedures
4-5