- ページ 8
ドア開閉システム Digiway SL500-LVのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Digiway SL500-LV 9 ページ。 Sliding gate motor drive
ページを印刷する10. Trouble Shooting Guide
10.1 Display information on main control board.
Between Pot and OSC button on the control board, there are two LEDs --- GREEN and RED. Different
combination and show different gate situations.
(1) Gate status LED
Gate Status (Position) \ LEDs
Gate in closed position
Gate is opening
Gate in opened position
Gate is closing
Gate stop in the middle
Gate stop in the middle: which means the gate stop by OSC input and at this position the auto close
does not apply.
(2) Input LEDs
Inputs LEDs\ Input status
OSC LED--- OSC input
PEB LED --- Photo Electric Beam-
Open Limit LED
Close Limit LED
10.2 Trouble Shooting Guide
Malfunction
Gate not open
Gate not close
Gate run little bit
then stop and both
Status LEDs flash
Gate opened or
closed position not
right
TROUBLE SHOOTING GUIDE
Status LED-Green
Slow Flash
Fast flash
on
off
Alternatively, flash
Input Active
off
off
Possible causes
1) No power
2) Already in opened
position
1) Safety input PEB active,
PEB LED is on
2) OSC input active, OSC
LED is on
1) No encoder input
2) mechanical jammed
1) encoder or limit wrong
2) Rack jumps over drive
pinion
Status LED-Red
Slow flash
Fast flash
Alternatively, flash
Input inactive
on
on
What to do
1) Check the power
2) Reset the power, remove 6 pins plug and
wait 20 seconds, and plug it back
1) Check the safety device, N/C contact
required.
2) Check control switch button in case it is
on
1) encoder plug wrong or faulty
2) power off and disengage the motor and
push and pull the gate manually
1) Reset the power, remove 6 pins plug and
wait 20 seconds, and plug it back
8
on
off
off
off
on
on