ページを印刷するBATTERY ASSEMBLING
Take out the bracket and open the battery compartment cover. Insert 2xAAA batteries
according to the correct polarity showed in the compartment.
After inserting the batteries, LCD will fully display for 3 seconds and the buzzer will so-
und BIBIBIBI, and then enter into normal display.
Default on display:
Temperature in ℃ (℃/℉switchable)
Temperature values indicates current room temperature, not dew point temperature
BUTTON FUNCTIONS
[SET/DEW POINT] BUTTON
In normal mode, press [SET/DEW POINT] to check current room temperature and
dew point temperature;
In normal mode, hold pressing [SET/DEW POINT] for three seconds to enter hum-
idity alert values setting;
In humidity alarm setting mode, press [SET/DEW POINT] to switch between high
humidity alert and low humidity alert. The setting order is high humidity alert values
—low humidity alert values--exit.
[ON/OFF] BUTTON
In normal mode, press [ON/OFF] button to turn on/off humidity alert alarm.
[C/F/▼] BUTTON
In normal mode, press [C/F/▼]to switch between ℃ and ℉;
In normal mode, press and hold [C/F/▼] button for 3 seconds to enter MOLD AL-
ERT & SCHIMMEL-GEFAHR ALERT setting. Press [C/F/▼] or [MAX/MIN▲] to
change the setting. The mould alert humidity values has 4 alternatives: 60%, 65%,
70%, 75%;
In MOLD ALERT & SCHIMMEL-GEFAHR setting mode, press and hold [C/F/▼] for
3 seconds to save the values and exit mould alert setting mode.
[MAX/MIN▲] BUTTON
Press [MAX/MIN▲] to check the maximum and minimum temperature & humidity
data;
Hold pressing [MAX/MIN▲] for 3 seconds to clear the humidity and temperature
values and re-register the data.