- ページ 10

プリンターアクセサリー Epson LQ-1170のPDF 製品サポート速報をオンラインで閲覧またはダウンロードできます。Epson LQ-1170 16 ページ。 Understanding and using escp/3 commands and syntax
Epson LQ-1170 にも：マニュアル (5 ページ), 製品サポート速報 (20 ページ), 製品サポート速報 (5 ページ), 技術概要 (7 ページ), インストールマニュアル (1 ページ), 組立マニュアル (8 ページ), 製品サポート速報 (20 ページ)

ESC ( t nl n2 dl .d2 d3 (Assign Character Tabie)

selectable with the ESC t n command. This is the table that will be replaced. Valid

corresponding to a registered table. lhii is the table that will replace the table

indicated by Variable d1. Valid Values for d2 are 0, 1,3,7,8, and 9 (see Table 2

0 -1 Italic

Table 1

After using the ESC ( t command, the ESC t n command MUST be sent to select the

table before printing from the new table. For example, the command ESC ( t 3 0 1 3

0 is sent (assign Registered Table 3 (PC950) to Selectable Table 1 (PC437). In order

to print the Q character (ASCII 245), the command ESC t 1 must be sent. In the Basic

programming language, the sequence would be as follows:

LPRINT CHR$(27);7';CHR$(l);

LPRINT CHR$(245)

Some ESC/P2 documentation may illustrate as many as 22 different Registered

Tables. The Registered Tables are a part of the character set, therefore, they are

contained in the Character Generator ROM. The CG ROM differs based upon the

destination country. For thii reason, only the above Registered Tables are available

on LQ-570, LQ-1070, LQ-870 and LQ-1170 printers sold for the U.S. market. Foreign

Character Generator ROMs ARE NOT available in the United States. The following

PSB No: P-0082

Page:

I I 9 I