ページを印刷する
SETUP
SETUP OVERVIEW
The indicator contains two main setup menus:
1. The "F" menu items configure the indicator to the attached load cell and is known as
"Configuration" settings.
technician.
2. The "A" menu items configure the serial communication port and general user options.
In setup mode the front panel keys become directional navigators to move around in the menus and to save
the selections.
ENTERING THE SETUP MENU
1. Power off the indicator.
2. Locate the slide switch on the rear cover and move it to the right.
NOTE: A metal plate held on by two drilled-head screws may conceal the slide switch.
The back cover may have a seal to keep unauthozed personnel from making changes
to the indicator.
3. Power on the indicator. The indicator shows " F 1" to indicate that you are in Setup
Menu mode.
NAVIGATING IN THE SETUP MENU
Use the directional keys shown in Figure 3-1 to move around in the Setup Menu Chart
shown in Figure 3-2 on the following page.
1. Press
setup heading.
2. Press the
3. Press
4. press the Set key to save the new selection. Press the
and return to the current heading,.
5. Repeat Steps 1 through 4 until the desired Setup & Configuration changes are made.
Most of these are entered by a qualified instrumentation
and
keys to move left and right to advance to the next or previous "F/A"
key once. The current saved setting is shown.
and
keys to scroll through selections for the current setup heading.
Figure 3-1: Setup Menu Key Assignments
SET
8
key to escape without saving