- ページ 18

ベビーモニター Motorola MBP25/2のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Motorola MBP25/2 27 ページ。 Digital video baby monitor
Motorola MBP25/2 にも：ユーザーマニュアル (30 ページ), クイック・スタート・マニュアル (2 ページ), クイック・スタート・マニュアル (6 ページ), クイック・スタート・マニュアル (8 ページ)

7. Help

Display

No Display

• Try recharging or replacing the battery pack.

• Reset the units. Disconnect the battery pack of the parent unit and unplug

both the units' electrical power, then plug them back in.

• Is the unit turned on?

• Press and hold the ON/OFF button P on the parent unit to turn it ON.

• Is the correct camera selected?

• Change the camera number, if necessary.

• Is the video display turned on?

• Press the VIDEO ON/OFF button V to turn it on.

• When operating using batteries only, the Display will go blank after about

4 minutes to save power. The unit is still active and will give you audio alerts.

You can reactivate the screen by pressing any button.

Registration

If the Baby Unit has lost its link with the Parent Unit

• Try recharging or replacing the battery pack.

• If the Baby Unit is too far away it may be going out of range, so move the

Baby Unit closer to the Parent Unit.

• Reset the units by disconnecting them from the battery and electrical power.

Wait about 15 seconds before reconnecting. Allow up to one minute for the

Baby Unit and the Parent Unit to synchronise.

• See 2.4 "Registration (Pairing)" , if there is a need to re-register the units.

Interference Noise

Interference on your parent unit

• Your baby and parent units may be too close. Move them farther apart.

• Make sure there is at least 3 to 6 feet (1 to 2 metres) between the 2 units to

avoid audio feedback.

Help