- ページ 14

ラジオ Motorola CLP seriesのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Motorola CLP series 48 ページ。 By wsi
Motorola CLP series にも：クイック・リファレンス・マニュアル (2 ページ), クイック・リファレンス (2 ページ), クイック・リファレンス (35 ページ), トラブルシューティングマニュアル (2 ページ)

68012000044-ED

Chapter 2 : Getting Started

2.3.3

Erasing Bluetooth Headset History and Adding Bluetooth Headset

Prerequisites: Turn the radio off.

Procedure:

1 Put the Bluetooth headset in pairing mode. Refer to your Bluetooth headset instructions leaflet.

2 Press and hold the Menu and Power buttons simultaneously until your radio shows the blue

LED.

NOTE: The CLP radio uses proximity pairing. Ensure the headset is close enough to the

CLP radio. Pairing process takes about 14 seconds.

2.4

Procedure:

1 To turn on the radio, press and hold the Power and Battery button until you hear a short tone

and the Smart Status Glow Ring illuminates.

2 To turn off the radio, press and hold the Power and Battery button until you hear a short tone

and the Smart Status Glow Ring indicator blinks once.

2.5

Procedure:

1 To increase the volume, press the + button.

NOTE: Radio has 16 increments of volume.

2 To decrease the volume, press the – button.

2.6

The radios offer various flexible carrying accessories. For Motorola Solutions approved accessories

list, refer to http://www.motorolasolutions.com/CLP.

Procedure:

1 To insert the radio into the holster, perform the following steps:

a Slide the bottom of the radio into the holster.

b Snap the top of the holster into the radio around the accessory connector.

2 To remove radio from the holster, pull either the top or bottom tab and pull the radio from the

holster.

NOTE: For optimal plug retention, loop the cord into the recess in the rear of the holster

when using a corded audio accessory.