- ページ 16

ラジオ Motorola CLP seriesのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Motorola CLP series 48 ページ。 By wsi
Motorola CLP series にも：クイック・リファレンス・マニュアル (2 ページ), クイック・リファレンス (2 ページ), クイック・リファレンス (35 ページ), トラブルシューティングマニュアル (2 ページ)

ページを印刷する

68012000044-ED

Chapter 2 : Getting Started

2 Speak clearly into the microphone on the audio accessory.

3 Release the PTT button to listen.

4 To receive calls, listen through the earpiece and press the PTT button to respond.

NOTE: The CLP Series radios always require the use of an audio accessory with

microphone and speaker.

2.7.1

Talk Range

Table 2: Talk Range

Application

Unit to Unit

With Repeater

2.8

Menu Setting

Procedure:

1 To navigate through the menu settings, press the Menu button.

2 To exit the menu, short press the PTT button or wait for three seconds.

NOTE: Voice Assisted Operation feature may not be available on certain previous

shipping radios.

2.8.1

Operations Using Menu Settings

This section explains operations using the menu settings.

NOTE:

It is not necessary to wait for the voice prompt to be completed before continuing with pressing

the next button.

If you are in the menu mode, short press PTT or wait 3 seconds to exit the menu.

The Voice Assisted Operation feature may not be available on certain previous shipping radios.

For single channel models, monitor, scan mode, and call tone are supported. Single channel

models support scan mode when you enable Dynamic Talkaround Scan on a repeater

channel through the Customer Programming Software (CPS).

Procedure:

1 Changing channel:

a Press Menu button to navigate to Channel.

b Press the + or the – button to change channel.

2 Entering Monitor Mode:

a Press Menu button to navigate to Monitor.

b Press the + to activate or the – button to deactivate monitor.

3 Entering Scan Mode:

Industrial (Inside steel/con-

crete industrial buildings)

Up to 100,000 ft

(9,200 m

Up to 250,000 ft

(23,200 m

Multi-Level (Inside multi-lev-

el buildings)

)

Up to 10 floors

)

Up to 20 floors