- ページ 8

ラジオ Motorola Talkabout T62のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Motorola Talkabout T62 28 ページ。 Portable two-way radios
Motorola Talkabout T62 にも：オーナーズマニュアル (17 ページ), マニュアル (31 ページ)

ページを印刷する

Note:

• You will see the

icon blinking on the display. This confirms that

the radio is in Easy Pairing mode waiting to receive the Channel

and Sub-Code settings from the Leader's radio. All Members'

radios will remain in this mode for 3 minutes.

• A group with many radios should have all users take this step at

the same time, so all radios can be programmed in one go.

3. On the Leader's radio, press and hold down the

until you hear a double beep.

Note:

• At the double beep, this radio's Channel and Sub-Code settings

will be transmitted, which will be received and copied by all the

other (Members') radios.

• The Leader's radio must make this transmission when all the

Members' radios are still in the Easy Pairing mode, otherwise the

transmission will not be picked up.

• On the Leader's radio, user must remember not to release the

button on the first (single) beep, otherwise this radio will become

another Member's radio. If that happens, you can press PTT to

escape, and retry the steps described in #3 again.

Internal Voice Operated Transmission/

Voice Operated Transmission (

Transmission is initiated by speaking into the microphone of

the radio/audio accessory instead of pushing the PTT button.

L3 = High Sensitivity for quiet environments

L2 = Medium Sensitivity for most environments

L1 = Low Sensitivity for noisy environments

1. Press

Menu/Lock until the

display. When audio accessory is connected, the

icon will be shown. The current setting (Off, L1–L3) will

flash.

2. Press

to select the sensitivity level.

3. Press the PTT button to exit menu or

Note: When using iVOX/VOX, there will be a short delay.

Dual Channel Monitor

Enables you to scan the current channel and another

button

channel alternately.

To set another channel and start Dual Channel Monitor:

1. Press

2. Press

3. Press

4. Press the PTT button or wait until time out to activate

5. To end Dual Channel Monitor, press

)

Note: If you set the same channel and Sub-Code as the current channel,

icon appears on the

continue set up.

Menu/Lock until the Dual Channel Monitor

icon appears. The Dual Channel Monitor icon will flash.

to select the channel then press

to select the Sub-Code.

Dual Channel Monitor. The screen will alternate between

home channel and Dual Channel Monitor channel.

Dual Channel Monitor does not work.

Menu/Lock to

Menu.

Menu/Lock.