Motorola Talkabout T62 Посібник користувача - Сторінка 8
Переглянути онлайн або завантажити pdf Посібник користувача для Радіо Motorola Talkabout T62. Motorola Talkabout T62 28 сторінок. Portable two-way radios
Також для Motorola Talkabout T62: Посібник користувача (17 сторінок), Посібник (31 сторінок)
Друкувати сторінку
Note:
• You will see the
icon blinking on the display. This confirms that
the radio is in Easy Pairing mode waiting to receive the Channel
and Sub-Code settings from the Leader's radio. All Members'
radios will remain in this mode for 3 minutes.
• A group with many radios should have all users take this step at
the same time, so all radios can be programmed in one go.
3. On the Leader's radio, press and hold down the
until you hear a double beep.
Note:
• At the double beep, this radio's Channel and Sub-Code settings
will be transmitted, which will be received and copied by all the
other (Members') radios.
• The Leader's radio must make this transmission when all the
Members' radios are still in the Easy Pairing mode, otherwise the
transmission will not be picked up.
• On the Leader's radio, user must remember not to release the
button on the first (single) beep, otherwise this radio will become
another Member's radio. If that happens, you can press PTT to
escape, and retry the steps described in #3 again.
Internal Voice Operated Transmission/
Voice Operated Transmission (
Transmission is initiated by speaking into the microphone of
the radio/audio accessory instead of pushing the PTT button.
L3 = High Sensitivity for quiet environments
L2 = Medium Sensitivity for most environments
L1 = Low Sensitivity for noisy environments
1. Press
Menu/Lock until the
display. When audio accessory is connected, the
icon will be shown. The current setting (Off, L1–L3) will
flash.
2. Press
or
to select the sensitivity level.
6
3. Press the PTT button to exit menu or
Note: When using iVOX/VOX, there will be a short delay.
Dual Channel Monitor
Enables you to scan the current channel and another
button
channel alternately.
To set another channel and start Dual Channel Monitor:
1. Press
2. Press
3. Press
4. Press the PTT button or wait until time out to activate
5. To end Dual Channel Monitor, press
/
)
Note: If you set the same channel and Sub-Code as the current channel,
icon appears on the
continue set up.
Menu/Lock until the Dual Channel Monitor
icon appears. The Dual Channel Monitor icon will flash.
or
to select the channel then press
or
to select the Sub-Code.
Dual Channel Monitor. The screen will alternate between
home channel and Dual Channel Monitor channel.
Dual Channel Monitor does not work.
Menu/Lock to
Menu.
Menu/Lock.