Replacing the Air Filter
Replace the air filter (or optional smoke filter) when you see
the
Check or Replace the air filter
prevent proper ventilation and can cause overheating and
damage the projector.
To obtain a replacement air filter or smoke filter, contact your
Epson authorized reseller. To find the nearest reseller, call
800-GO-EPSON (800-463-7766). Or you can purchase
online at www.epsonstore.com (U.S. sales) or www.epson.ca
(Canadian sales).
Follow these steps:
1. Turn off the projector and unplug the power cord.
2. Lift the air filter cover by pulling up the tabs.
3. Remove the filter by pulling it straight out from the center.
4. Insert the new filter with the tabs facing the front of the
projector.
5. Close the air filter cover.
6. Reset the air filter timer as described in the next section.
message. Dust clogs
12/07
Resetting the Air Filter Timer
1. Plug the projector in and turn it on.
2. Press the
button on the remote control, select
Menu
from the Reset menu, then press
Air Filter Time
3. When you see the confirmation message, select
press
.
Enter
4. When you're finished, press
Note: The air filter usage timer shows 0H until you've used the
filter for at least 10 hours.
Replacing the Lamp
Although lamp life results vary depending on environmental
conditions and usage, the projection lamp typically lasts about
3400 hours in high brightness mode or 3900 hours in low
brightness mode. It is time to replace the lamp when:
❏ The projected image gets darker or starts to deteriorate.
❏ The message
Replace the Lamp
when the lamp comes on and the lamp warning light
flashes orange. To maintain projector brightness and image
quality, replace the lamp as soon as possible.
❏ The lamp warning light
out).
Note: Turn off the projector when not in use to prolong the life of
the projection lamp.
You can see how long the lamp has been in use by checking
the
option in the projector's Info menu. (See the
Lamp Hours
User's Guide for more information.)
Contact your Epson authorized reseller for a replacement
lamp and request part number
nearest reseller, call 800-GO-EPSON (800-463-7766). Or
you can purchase online at www.epsonstore.com (U.S. sales)
or www.epson.ca (Canadian sales).
Follow these steps to replace the lamp:
1. Turn off the projector.
2. When the P Power light stops flashing, unplug the power
cord.
Warning: Let the lamp cool fully before replacing it.
In the unlikely event that the lamp has broken, small glass
fragments may be present and should be removed carefully to
avoid injury.
3. Let the projector cool for at least an hour (if it has been on).
The lamp is extremely hot immediately after use.
Epson PowerLite 6110i
Reset
Enter
, then
Yes
to exit the menu system.
Menu
appears on the screen and
flashes red (the lamp is burnt
. To find the
V13H010L45
.
13
ページを印刷する