- ページ 6
エアコン Toshiba 24E2KVSG-AのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Toshiba 24E2KVSG-A 12 ページ。
ページを印刷する
TIMER OPERATION
15
Set the timer when the air conditioner is operating.
Setting the ON Timer
Press
: Set the desired
1
ON timer.
2
Press
: Set the timer.
3
Press
: Cancel the timer.
Note:
● Keep the remote control in accessible transmission to the indoor unit;
otherwise, the time lag of up to 15 minutes will occur.
● The setting will be saved for the next same operation.
PRESET OPERATION
16
Set your preferred operation for future use. The setting will be memorized by
the unit for future operation (except airflow direction).
1. Select your preferred operation.
2. Press and hold
The P mark displays.
3. Press
: Operate the preset operation.
DISPLAY LAMP BRIGHTNESS ADJUSTMENT
17
To decrease the display lamp brightness or turn it off.
1. Press and hold
or
) is shown on remote control LCD then release the button.
2. Press
or
Rise
Decrease
Remote control
LCD
Lamp illuminates full brightness.
Lamp illuminates 50% brightness.
Lamp illuminates 50% brightness and the
operation lamp is turned off.
All lamps are turned off.
● In the examples of
and
going off.
AUTO RESTART FUNCTION SETTING
18
This product is designed so that, after a power failure, it can restart
automatically in the same operating mode as before the power failure.
Information
The product is shipped with Auto Restart function in the ON position.
Turn it OFF if this function is not required.
How to turn OFF the Auto Restart Function
●
Press and hold the [OPERATION] button on the indoor unit for 3 seconds
(3 beep sounds but OPERATION lamp does not blink).
How to turn ON the Auto Restart Function
● ●
Press and hold the [OPERATION] button on the indoor unit for 3 seconds
(3 beep sounds and OPERATION lamp blink 5 time/sec for 5 seconds).
Note:
●
In case of ON timer or OFF timer are set, AUTO RESTART OPERATION
does not activate.
●
Default setting of AUTO RESTART OPERATION is ON.
Setting the OFF Timer
Press
: Set the desired
OFF timer.
Press
: Set the timer.
Press
: Cancel the timer.
for 3 seconds to memorize the setting.
for 3 seconds until brightness level (
to adjust brightness in 4 levels.
Operation display
, the lamp illuminates for 5 seconds before
SELF CLEANING OPERATION
19
(COOL AND DRY OPERATION ONLY)
To protect bad smell caused by the humidity in the indoor unit.
1. If the
the fan will continue to run for other 30 minutes, then it will turn off
automatically. This will reduce the moisture in the indoor unit.
2. To stop the unit immediately, press the
within 30 seconds.
TEMPORARY OPERATION
20
In case of the misplaced or discharged remote control
● Pressing the RESET button, the unit can start or
stop without using the remote control.
● Operation mode is set on AUTOMATIC operation,
preset temperature is 24°C and fan operation is
automatic speed.
21
REMOTE CONTROL A-B SELECTION
To separate using of remote control for each indoor unit in case of 2 air
conditioners are installed nearly.
Remote Control B Setup.
1. Press RESET button on the indoor unit to turn the air conditioner ON.
2. Point the remote control at the indoor unit.
3. Push and hold
pencil. "00" will be shown on the display. (Picture 1)
4. Press
"00" will disappear and the air conditioner will turn OFF. The Remote
Control B is memorized. (Picture 2)
,
,
Note: 1. Repeat above step to reset Remote Control to be A.
2. Remote Control A has not "A" display.
3. Default setting of Remote Control from factory is A.
Brightness
100%
50%
22
OPERATION AND PERFORMANCE
1. Three-minute protection feature: To prevent the unit from being activated
50%
for 3 minutes when suddenly restarted or switched to ON.
2. Preheating operation: Warm up the unit for 5 minutes before the heating
operation starts.
3. Warm air control: When the room temperature reaches the set
temperature, the fan speed is automatically reduced and the outdoor unit
All turned off
will stop.
4. Automatic defrosting: Fans will stop during defrost operation.
5. Heating capacity: Heat is absorbed from outdoors and released into
the room. When the outdoor temperature is too low, use another
recommended heating apparatus in combination with the air conditioner.
6. Consideration for accumulated snow: Select the position for outdoor unit
where it will not be subjected to snow drifts, accumulation of leaves or
other seasonal debris.
7. Some minor cracking sound may occur when unit operating. This is normal
because the cracking sound may be caused by expansion/contraction of
plastic.
Note: Item 2 to 6 for Heating model
Air conditioner operating conditions
Operation
Heating
Cooling
Dry
button is pressed once during "Cool" or "Dry" mode,
button on the Remote Control by the tip of the
during pushing
. "B" will show on the display and
1
2
Temp.
Outdoor Temperature
–15°C ~ 24°C
–10°C ~ 46°C
–10°C ~ 46°C
more 2 times
Room Temperature
Less than 28°C
21°C ~ 32°C
17°C ~ 32°C