- ページ 5

ソフトウェア Epson Stylus Pro 4880 ColorBurst Edition - Stylus Pro 4880 ColorBurstのPDF セットアップマニュアルをオンラインで閲覧またはダウンロードできます。Epson Stylus Pro 4880 ColorBurst Edition - Stylus Pro 4880 ColorBurst 16 ページ。 Warranty statement
Epson Stylus Pro 4880 ColorBurst Edition - Stylus Pro 4880 ColorBurst にも：仕様書 (6 ページ), はじめに (13 ページ), パンフレット＆スペック (6 ページ), クイック・リファレンス・マニュアル (12 ページ), ネットワーク・マニュアル (46 ページ), インストレーション・マニュアル (4 ページ), 製品情報マニュアル (16 ページ), 限定保証 (12 ページ)

Removing the protective materials

To prevent damage during shipping, your printer

is packed with several pieces of protective

material. Remove the protective material from

your printer before using it. Open the top cover,

loosen the two screws, and then pull out the

carriage fixed board.

You also need to unlock the print head, by pulling

the green tab on the left side of the print head.

Caution:

Be careful not to touch the parts highlighted

below; otherwise, the printer may be damaged.

Setting Up the Printer

Connecting the power cord

1. Check the label on the back of the printer to

make sure the voltage required by the printer

matches that of the wall outlet. Also, make

sure that you have the correct power cord for

your power source.

Caution:

It is not possible to change the printer's

voltage. If the rated voltage and your outlet

voltage do not match, do not plug in the

power cord, and contact your dealer for

assistance.

2. Connect the power cord to the AC inlet on the

back of the printer.

3. Plug the power cord into a properly grounded

wall outlet.

Caution:

Do not use an outlet that is controlled by an

automatic timer or a wall switch; otherwise,

accidental shut down or damage to your

printer may occur.

AC inlet