Epson Stylus Pro 4880 ColorBurst Edition - Stylus Pro 4880 ColorBurst 설정 매뉴얼 - 페이지 5

{카테고리_이름} Epson Stylus Pro 4880 ColorBurst Edition - Stylus Pro 4880 ColorBurst에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson Stylus Pro 4880 ColorBurst Edition - Stylus Pro 4880 ColorBurst 16 페이지. Warranty statement
Epson Stylus Pro 4880 ColorBurst Edition - Stylus Pro 4880 ColorBurst에 대해서도 마찬가지입니다: 사양 시트 (6 페이지), 시작하기 (13 페이지), 브로셔 및 사양 (6 페이지), 빠른 참조 매뉴얼 (12 페이지), 네트워크 매뉴얼 (46 페이지), 설치 매뉴얼 (4 페이지), 제품 정보 매뉴얼 (16 페이지), 제한 보증 (12 페이지)

페이지 인쇄
Epson Stylus Pro 4880 ColorBurst Edition - Stylus Pro 4880 ColorBurst 설정 매뉴얼
Removing the protective materials
To prevent damage during shipping, your printer
is packed with several pieces of protective
material. Remove the protective material from
your printer before using it. Open the top cover,
loosen the two screws, and then pull out the
carriage fixed board.
You also need to unlock the print head, by pulling
the green tab on the left side of the print head.
c
Caution:
Be careful not to touch the parts highlighted
below; otherwise, the printer may be damaged.

Setting Up the Printer

Connecting the power cord
1. Check the label on the back of the printer to
make sure the voltage required by the printer
matches that of the wall outlet. Also, make
sure that you have the correct power cord for
your power source.
c
Caution:
It is not possible to change the printer's
voltage. If the rated voltage and your outlet
voltage do not match, do not plug in the
power cord, and contact your dealer for
assistance.
2. Connect the power cord to the AC inlet on the
back of the printer.
3. Plug the power cord into a properly grounded
wall outlet.
c
Caution:
Do not use an outlet that is controlled by an
automatic timer or a wall switch; otherwise,
accidental shut down or damage to your
printer may occur.
AC inlet
3