Epson Stylus Pro 4880 ColorBurst Edition - Stylus Pro 4880 ColorBurst 설정 매뉴얼 - 페이지 7

{카테고리_이름} Epson Stylus Pro 4880 ColorBurst Edition - Stylus Pro 4880 ColorBurst에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson Stylus Pro 4880 ColorBurst Edition - Stylus Pro 4880 ColorBurst 16 페이지. Warranty statement
Epson Stylus Pro 4880 ColorBurst Edition - Stylus Pro 4880 ColorBurst에 대해서도 마찬가지입니다: 사양 시트 (6 페이지), 시작하기 (13 페이지), 브로셔 및 사양 (6 페이지), 빠른 참조 매뉴얼 (12 페이지), 네트워크 매뉴얼 (46 페이지), 설치 매뉴얼 (4 페이지), 제품 정보 매뉴얼 (16 페이지), 제한 보증 (12 페이지)

페이지 인쇄
Epson Stylus Pro 4880 ColorBurst Edition - Stylus Pro 4880 ColorBurst 설정 매뉴얼
3. Raise the ink levers.
4. Remove the package from an ink cartridge,
and then shake the ink cartridge well for best
results.
5. Hold the ink cartridge with the arrow mark
facing up and pointing to the rear of the
printer, and then insert it in the slot.
6. Repeat steps 4 to 5 to install the other ink
cartridges.
7. After inserting all ink cartridges in their
corresponding slot, lower the ink levers. The
printer starts initial ink charging.
8. After approximately two minutes, ink lever
messages appear on the LCD panel. Raise or
lower the ink levers accordingly until READY
appears on the LCD panel, which indicates
initial ink charging is completed.
c
Caution:
Never perform the following tasks while the
Pause light is flashing; otherwise, damage
may occur.
❏ Turn off the printer.
❏ Open the top cover.
❏ Remove the rear cover.
❏ Move the paper lever to the released
position.
❏ Remove the ink cartridges.
❏ Remove the maintenance tank.
❏ Unplug the power cord.
9. Close the ink compartment cover(s).
Note:
If you have installed 220 ml ink cartridges, do not
close the ink compartment cover(s).
5