- ページ 11
オール・イン・ワン・プリンター Toshiba MJ-1101のPDF サービスマニュアル補遺をオンラインで閲覧またはダウンロードできます。Toshiba MJ-1101 17 ページ。 Supplement to the troubleshooting section
ページを印刷する
Error code
Phenomenon
Possible cause
EA70
- When more than one
10. Abnormalities in paper
EA60
sheet of paper is
transport section
CC30
loaded on the buffer
CC41
tray, the first sheet is
pushed out of the tray
by the second sheet.
- When more than one
sheet of paper is
loaded on the buffer
tray, the leading edge
of the second sheet is
caught and thus a
paper jam occurs.
- When paper is
11. Insufficient ejection of
transported from the
front/rear transport roller
buffer tray to the
finishing tray, the
paper is run on the
front or rear alignment
plate.
- When paper is
loaded on the finishing
tray, the front and rear
alignment plates
excessibly push the
paper.
- When paper is
transported from the
12. Wrong operation by users
finishing tray to the
during printing
movable tray, the
paper exit guide
catches the paper and
thus a motor error
occurs because the
paper cannot exit.
Items to confirm / Countermeasures
Check if there is any scratch, foreign matter, paper dust or remained paper that disturb the paper transport in the
paper transport section. Remove if any.
If the front and rear transport rollers are not ejected from the transport guide at 0.5 mm or more, replace the
transport guide (GUIDE-FEED-LOW).
Transport guide
An EA70 error may occur if paper exit is disturbed during printing.
Paper transport
section
0.5 mm or more
Front transport roller
Rear transport roller
Precautions / Remarks