- ページ 12

オール・イン・ワン・プリンター Toshiba MJ-1101のPDF サービスマニュアル補遺をオンラインで閲覧またはダウンロードできます。Toshiba MJ-1101 17 ページ。 Supplement to the troubleshooting section

Toshiba MJ-1101 サービスマニュアル補遺
Error code
Phenomenon
Possible cause
EAE0
Paper jamming
1. Loose connection
(Loose connection may cause
false operation or detection.)
2. Movable tray paper exist
sensor harness (HRNS-SFTTRY)
short circuited
(Loose connection may cause
false operation or detection.)
Items to confirm / Countermeasures
A. Check if the interface cable of the Finisher is connected securely. Reconnect it if not.
Interface cable
B. Check if the connectors (CN12 and CN14) of the Finisher control PC board are connected securely. Reconnect
them if not.
C. Check if the connectors (CN1 and CN2) of the CNV board are connected securely and the locking support is
installed properly. Reconnect them if not.
Locking support
Connector
Check if the harness (HRMS-SFTTRY) of the movable tray paper exist sensor is short circuited or if its wiring is
proper. Replace the harness if it is short circuited.
HRNS-SFTTRY (6LB12426000)
Connector
Abnormal
Precautions / Remarks
The harness wiring must be under the screw and inside of the Mylar, and the
harness must be wired along with the groove of the plate as shown on the left.
Be sure that the harness is covered by the Mylar.