- ページ 2

エンクロージャー CRU DataPort DP27のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。CRU DataPort DP27 4 ページ。 Slimline enclosure

CRU DataPort DP27 Quick Start Guide

1 Slimline Frame inStallation

a. Install the DP27 into your computer's optical bay using the instructions provided by your com-

puter manufacturer.

The DP27 requires 5v DC power provided over a 6-pin slimline cable. You may

require a third party 6-pin slimline to 15-pin SATA power cable (sold separately) if

you are using the DP27 in an ATX case or server chassis.

2 Carrier eJeCtion

2.1 PuSh-Button VerSion

Slide the Eject button to the left and then press in to release the carrier from the frame (see

Figure 1).

2.2 KeyloCK VerSion

Firmly press the included key into the square keyhole on the left side of the frame to eject the

carrier (see Figure 2).

Figure 1.

keyhole to eject the carrier.

3 DriVe inStallation

a. On the rear of the carrier are two tabs holding the cover

of the carrier in place. Separate the tabs and pull the

cover apart from the carrier.

b. Insert a 2.5" 7mm SATA drive with the top label facing

up into the carrier by compressing the foam spring and

placing the drive into the carrier bottom (see Figure 3).

Ensure that the unified SATA and power data connector

is facing out of the rear of the carrier.

Insert the key into the

Figure 2.

Insert the key into the

keyhole to eject the carrier.

Figure 3.

carrier.

Figure 4.

cover to secure it.

Insert the drive into the

Press down on the