- ページ 7

カー・ステレオ・システム Crutchfield 016 0045のPDF マスターシートをオンラインで閲覧またはダウンロードできます。Crutchfield 016 0045 8 ページ。 For dodge dakota

016 0045

Rear Door Speakers -- Quad Cab

1. Pry open screw cover in door release trim and

remove one (1) Torx T-25 screw.

2. Remove one (1) Torx T-25 screw located behind

door pull handle.

3. Remove two (2) phillips screws from bottom edge of

door panel.

4. Lift door panel, disconnect door lock rod and door

release rod as shown (Figure 1). Disconnect wiring

harness and remove door panel.

5. Remove three (3) phillips screws securing factory

speaker assembly. Pull off assembly, disconnect and

remove.

6. Secure new speaker to speaker adaptor bracket

following instructions supplied with adaptor

brackets.

7. Connect speaker wiring adaptor of replacement

speaker to vehicle speaker connector. Secure

speaker/bracket assembly to door with screws

previously removed (Figure 2).

8. Test speaker operation and reinstall door panel by

reversing removal steps.

SAFETY CHECK

Check that wires do not interfere with window operation.

Test window and door lock operation.

1-800-955-9094

Technical Service

FIGURE 1

Arm/clip

Speaker/Bracket Assembly

FIGURE 2

NOTES:

Please read first

• Instructions show factory size speakers or speakers

with adaptor brackets only. Cutting or fabricating (not

shown) will be required for other speaker sizes.

Door Release Linkage Rod

(Door Lock Linkage Rod has

same appearance - one shown)

Door Pull Handle

Screw Cover

Door Panel