Crutchfield 016 0045 마스터 시트 - 페이지 7

{카테고리_이름} Crutchfield 016 0045에 대한 마스터 시트을 온라인으로 검색하거나 PDF를 다운로드하세요. Crutchfield 016 0045 8 페이지. For dodge dakota

016 0045

Rear Door Speakers -- Quad Cab

1. Pry open screw cover in door release trim and

remove one (1) Torx T-25 screw.

2. Remove one (1) Torx T-25 screw located behind

door pull handle.

3. Remove two (2) phillips screws from bottom edge of

door panel.

4. Lift door panel, disconnect door lock rod and door

release rod as shown (Figure 1). Disconnect wiring

harness and remove door panel.

5. Remove three (3) phillips screws securing factory

speaker assembly. Pull off assembly, disconnect and

remove.

6. Secure new speaker to speaker adaptor bracket

following instructions supplied with adaptor

brackets.

7. Connect speaker wiring adaptor of replacement

speaker to vehicle speaker connector. Secure

speaker/bracket assembly to door with screws

previously removed (Figure 2).

8. Test speaker operation and reinstall door panel by

reversing removal steps.

SAFETY CHECK

Check that wires do not interfere with window operation.

Test window and door lock operation.

1-800-955-9094

Technical Service

FIGURE 1

Arm/clip

Speaker/Bracket Assembly

FIGURE 2

NOTES:

Please read first

• Instructions show factory size speakers or speakers

with adaptor brackets only. Cutting or fabricating (not

shown) will be required for other speaker sizes.

Door Release Linkage Rod

(Door Lock Linkage Rod has

same appearance - one shown)

Door Pull Handle

Screw Cover

Door Panel