- ページ 10

電気ヒーター Dimplex Quantum seriesのPDF 設置および操作マニュアルをオンラインで閲覧またはダウンロードできます。Dimplex Quantum series 12 ページ。
Dimplex Quantum series にも：クイック・スタート・マニュアル (12 ページ)

ページを印刷する

15. The third row of energy cells is positioned in a manner

similar to the ﬁ rst row. Again be careful not to damage

or dislodge the element. (Fig. 15)

17. Remember the top row of energy cells must be ﬁ tted

upside down. (Fig. 17)

Check that all the energy cells are secure and evenly located.

Ensure the screws retaining the heater to the wall are fully tightened, once the energy

retention cells are fully loaded. (Fig. 8, page 7)

IMPORTANT

Double check all mains connections are secure and excess cable is restrained and not in

contact with any of the heater casing.

Reassembly

To replace the front panel, bottom grille and side panels, reverse steps Figs. 4, 5 & 6 (page

6) of these instructions under the section headed Preparation.

Ensure all ﬁ xings are secure.

Once installed DO NOT attempt to reposition the heater without ﬁ rst unloading the

energy cells.

Fig. 1

Fig. 15

16. Fit the fourth row of energy cells above the third row

in the upside position. (Fig. 16). Repeat for the ﬁ fth and

sixth rows of energy cells built around the third element

to complete the core build.

Fig. 1

Fig. 17

18. Close the core by reﬁ tting the inner front panel complete

with insulation. Ensure the bottom tabs are located inside

the chassis and that the screws are tightly secured down

each edge. (Fig. 18)

Fig.

Fig. 16

Fig. 1

Fig. 18

- 10 -