- ページ 26

アンプ Pioneer A9のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Pioneer A9 28 ページ。 Non swithing amp
Pioneer A9 にも：取扱説明書 (28 ページ), サービスマニュアル (13 ページ), 取扱説明書 (16 ページ), サービスマニュアル (5 ページ)

ページを印刷する

Additional information

Problem

Can't operate the remote

control.

The display is dark or off.

XM radio messages

Message

Cause

ANTENNA

The XM antenna is not connected.

ANT ERR

A short-circuit occurring in the antenna or

surrounding antenna cable.

UPDATING

The radio is being updated with the latest

encryption code.

NO SIGNAL

The XM signal is too weak at the current

location.

The receiver is acquiring audio or program

information.

OFF AIR

The channel currently selected has stopped

broadcasting.

CH– – –

You have selected a channel that does not

exist, or that you have not subscribed to.

There is no artist name/feature, song/

program title, or channel category associated

with the channel at this time.

Specifications

Amplifier section

Power output specification is for when power

supply is 120 V.

•

Continuous power output (both channels

driven at 20 Hz to 20 kHz)**

THD 0.2 %, 4

. . . . . . . . . . . . . . . . . 70 W + 70 W

THD 0.2 %, 8

. . . . . . . . . . . . . . . . . 55 W + 55 W

Remedy

• Replace the battery (refer to page 7).

• Operate within 7 m (23 ft.), 30° of the remote sensor on the front panel

(refer to page 13).

• Remove the obstacle or operate from another position.

• Avoid exposing the remote sensor on the front panel to direct light.

• Press DIMMER on the remote repeatedly to return to the default.

•

channels driven at 1 kHz)

THD 1.0 %, 4

THD 1.0 %, 8

•

20 Hz to 20 kHz, 25 W, 8

* Measured with DIRECT button switched on.

** Measured by Audio Spectrum Analyzer

Action

Check that the XM antenna cable is attached

securely.

Make sure that there is nothing unusual with

the antenna or antenna cable. Switch the

power off then back on again.

Wait until the encryption code has been

updated. Channels 00 and 01 should function

normally.

n/a

Wait until the information has been received.

Select another channel.

The receiver will automatically switch to

channel 001 (or the last selected channel).

No action needed.

FTC Continuous power output (both

. . . . . . . . . . . . . . . . . 65 W + 65 W

. . . . . . . . . . . . . . . . . 55 W + 55 W

Total harmonic distortion**

. . . . . . . . . . . . 0.05 %*