Pioneer A9 사용 설명서 - 페이지 26

{카테고리_이름} Pioneer A9에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer A9 28 페이지. Non swithing amp
Pioneer A9에 대해서도 마찬가지입니다: 사용 설명서 (28 페이지), 서비스 매뉴얼 (13 페이지), 사용 설명서 (16 페이지), 서비스 매뉴얼 (5 페이지)

Pioneer A9 사용 설명서
07
Additional information
Problem
Can't operate the remote
control.
The display is dark or off.

XM radio messages

Message
Cause
ANTENNA
The XM antenna is not connected.
ANT ERR
A short-circuit occurring in the antenna or
surrounding antenna cable.
UPDATING
The radio is being updated with the latest
encryption code.
NO SIGNAL
The XM signal is too weak at the current
location.
LOADING
The receiver is acquiring audio or program
information.
OFF AIR
The channel currently selected has stopped
broadcasting.
CH– – –
You have selected a channel that does not
exist, or that you have not subscribed to.
There is no artist name/feature, song/
program title, or channel category associated
with the channel at this time.

Specifications

Amplifier section
Power output specification is for when power
supply is 120 V.
Continuous power output (both channels
driven at 20 Hz to 20 kHz)**
Ω
THD 0.2 %, 4
. . . . . . . . . . . . . . . . . 70 W + 70 W
Ω
THD 0.2 %, 8
. . . . . . . . . . . . . . . . . 55 W + 55 W
26
En
Remedy
• Replace the battery (refer to page 7).
• Operate within 7 m (23 ft.), 30° of the remote sensor on the front panel
(refer to page 13).
• Remove the obstacle or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct light.
• Press DIMMER on the remote repeatedly to return to the default.
channels driven at 1 kHz)
THD 1.0 %, 4
THD 1.0 %, 8
20 Hz to 20 kHz, 25 W, 8
* Measured with DIRECT button switched on.
** Measured by Audio Spectrum Analyzer
Action
Check that the XM antenna cable is attached
securely.
Make sure that there is nothing unusual with
the antenna or antenna cable. Switch the
power off then back on again.
Wait until the encryption code has been
updated. Channels 00 and 01 should function
normally.
n/a
Wait until the information has been received.
Select another channel.
The receiver will automatically switch to
channel 001 (or the last selected channel).
No action needed.
FTC Continuous power output (both
Ω
. . . . . . . . . . . . . . . . . 65 W + 65 W
Ω
. . . . . . . . . . . . . . . . . 55 W + 55 W
Total harmonic distortion**
Ω
. . . . . . . . . . . . 0.05 %*