- ページ 4

自動車部品 Dinan Tronics D440-0052のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Dinan Tronics D440-0052 7 ページ。

6. Study the locking system on the new DINANTronics connectors until you are

familiar with how the two connector halves are released. Some locks will require

the use of a small flat blade screwdriver to release the tang.

7. Disconnect the wiring harness from the pressure sensor.

8. Install the DINANTronics harness in between the charge air tube pressure sensor,

and the factory wiring harness. The connectors are unique, and can only be installed

one way. Make sure that the locking tangs on both connections are secure.

9. Route the DINANTronics harness to sensor #2, located on the intake manifold as

shown below.

10. Like the previous sensor, install the DINANTronics harness in between the manifold

pressure sensor and the factory wiring harness. The connectors are unique, and can

only be installed one way. Make sure that the locking tangs on both connections are

secure.

INS440-0052

Page 4 of 7

Rev 9/18/17