Dinan Tronics D440-0052 Інструкція з монтажу Посібник з монтажу - Сторінка 4
Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Автомобільні запчастини Dinan Tronics D440-0052. Dinan Tronics D440-0052 7 сторінок.
Друкувати сторінку6. Study the locking system on the new DINANTronics connectors until you are
familiar with how the two connector halves are released. Some locks will require
the use of a small flat blade screwdriver to release the tang.
7. Disconnect the wiring harness from the pressure sensor.
8. Install the DINANTronics harness in between the charge air tube pressure sensor,
and the factory wiring harness. The connectors are unique, and can only be installed
one way. Make sure that the locking tangs on both connections are secure.
9. Route the DINANTronics harness to sensor #2, located on the intake manifold as
shown below.
10. Like the previous sensor, install the DINANTronics harness in between the manifold
pressure sensor and the factory wiring harness. The connectors are unique, and can
only be installed one way. Make sure that the locking tangs on both connections are
secure.
INS440-0052
#2
Page 4 of 7
Rev 9/18/17