アクセサリー Aeotec AEOEZWA019のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Aeotec AEOEZWA019 8 ページ。

Water Sensor 7 Pro

SKU: AEOEZWA019

Quickstart

This is a secure Alarm Sensor for Europe. To run this device please insert fresh 1 * 1/2 AA batteries. Please

make sure the internal battery is fully charged. The DSK for the S2 inclusion can be found inside the sensors

packaging.

If your Z-Wave gateway supports SmartStart: scan the QR code on Water Sensor 7 Pro using the gateway's

app. Your sensor will join your Z-Wave network automatically.

Important safety information

Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or

may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage

resulting from failure to comply with the instructions in this manual or any other material. Use this equipment

only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or

batteries in a fire or near open heat sources.

What is Z-Wave?

Z-Wave is the international wireless protocol for communication in the Smart Home. This device is suited for

use in the region mentioned in the Quickstart section.

Z-Wave ensures a reliable communication by reconfirming

every message (two-way communication) and every mains

powered node can act as a repeater for other nodes (meshed

network) in case the receiver is not in direct wireless range of

the transmitter.

This device and every other certified Z-Wave device can

be used together with any other certified Z-Wave device

regardless of brand and origin as long as both are suited for

the same frequency range.

If a device supports secure communication it will communicate with other devices secure as long as this

device provides the same or a higher level of security. Otherwise it will automatically turn into a lower level of

security to maintain backward compatibility.