- ページ 2

アクセサリー Aeotec AEOEZWA019のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Aeotec AEOEZWA019 8 ページ。

SmartStart. Available in selected Z-Wave Plus devices built upon 500 series technology and all devices built

upon 700 series technology, SmartStart lets you setup Z-Wave devices in seconds.Using SmartStart enabled

apps, simply scan the QR code on any compatible app to connect it to your Z-Wave gateway.

For more information about Z-Wave technology, devices, white papers etc. please refer to www.z-wave.info.

Product Description

The AEOTEC Water Sensor 7 Pro is a sensor, which detects water leakage, measures temperature and

humidity. The sensor is easily retrofittable.

Thanks to its slim design the AEOTEC Water Sensor 7 Pro can be installed in any bathroom, behind a kitchen

sink or in any other tight space. The sensor just has to be installed on the wall and the sensor probe must be

put on the floor.

By using the internal temperature and humidity sensor, the device will report on any significant change.

Tripple clicking the tamper button includes (adds) and excludes (removes) the device. A single click on the

button will wake up the device. The device supports the Z-Wave Security S2 framework with authenticated and

unauthenticated network keys. Please follow the instructions on the central controller when including. The

device also supports SmartStart.

Please read the user manual before installing the product.

In order to include (add) a Z-Wave device to a network it must be in factory default state. Please make sure

to reset the device into factory default. You can do this by performing an Exclusion operation as described

below in the manual. Every Z-Wave controller is able to perform this operation however it is recommended to

use the primary controller of the previous network to make sure the very device is excluded properly from this

network.

Reset to factory default

This device also allows to be reset without any involvement of a Z-Wave controller. This procedure should only

be used when the primary controller is inoperable.

Once Cover is removed and the tamper switch is tripped, push the tamper for 5 seconds until the RED LED

blinks once. Then release tamper and push it again for 5 seconds while the RED LED is blinking until the

GREEN LED blinks once.

Safety Warning for Batteries

The product contains batteries. Please remove the batteries when the device is not used. Do not mix batteries

of different charging level or different brands.

The sensor can be mounted on the wall. Mounting can be accomplished either using the tape by peeling off the

protection foil or using two screws with the holes inside the battery compartment.

Water Sensor probe which is hardwired to the Main Unit must be put on the floor or onto any other surface,

where water leakage must be detected.

Inclusion/Exclusion

On factory default the device does not belong to any Z-Wave network. The device needs to be added to an

existing wireless network to communicate with the devices of this network. This process is called Inclusion.

Devices can also be removed from a network. This process is called Exclusion. Both processes are initiated

by the primary controller of the Z-Wave network. This controller is turned into exclusion respective inclusion

mode. Inclusion and Exclusion is then performed doing a special manual action right on the device.

Inclusion (If your gateway does not support SmartStart)

1. Open the housing.

2. Remove the battery protection.

3. Press the tamper on the side of the appliance three times quickly.