- ページ 19

ボイラー Ariston EuroCombi Type C A27 MFFIのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Ariston EuroCombi Type C A27 MFFI 28 ページ。 Type c boiler
Ariston EuroCombi Type C A27 MFFI にも：取付説明書 (24 ページ), 整備要領 (32 ページ), 整備要領 (32 ページ), 整備要領 (32 ページ)

ページを印刷する

3.4

Initial Start-up

3.5

Operational

Adjustments

B023

The checks to be run before initial start-up are as follows:

1. Make sure that:

- the screw on the automatic air valve has been loosened when the

system is full;

- If the water pressure in the system is below 1 bar, bring it up to the appro-

priate level;

- Check to see whether the gas cock is closed;

- Make sure that the electrical connection has been made properly and that

the earth wire is connected to an efficient earthing system;

- Supply power to the boiler by pressing the On/Off switch <L> - the L.E.D. "I"

will turn on - turn the selector knob "C" to the < winter> setting. This will start

the circulation pump. After 7 seconds, the boiler will signal a shut-

down due to failure ignition. Leave the boiler as it is until all of the air has

been bled from the lines.

- Loosen the cap on the head of the pump to eliminate any air pockets;

- Repeat the procedure for bleeding the radiators of air;

- Open the taps for a brief period;

- Check the system pressure and, if it has dropped, open the filling-loop

again to bring the pressure back up to 1 bar.

2. Check the exhaust flue for the fumes produced by combustion.

3. Make sure that all gate valves are open;

4. Turn on the gas cock and check the seals on the connections, including the

one for the burner, making sure that the meter does not signal the passage

of gas. Check the connections with a soap solution and eliminate any leaks.

5. Press the reset button "A" for the lighting system; the spark will light the

main burner. If the burner does not light the first time, repeat the procedure.

6. Check the minimum and maximum pressure values for the gas going to the

burner; adjust it if needed using the values indicated in the table in

section 4.

(See the relative section for burner pressure adjustment within the servicing

manual).

The boiler was designed to make it easy to regulate and check the various

features. To access the areas where the adjustment and control devices are

located, simply remove the plugs by pressing from the inside, unscrew the

screws "A" and remove the bottom part of the instrument panel, rotating it

upward.

Right hand side service panel also provides access to:

- the power supply cord connector;

- the fuses.

Left hand side:

- the potentiometer for regulating the ignition delay (anti-cycling) feature, which

can be set from 0 to 2 minutes (factory set at 1 minute);

- the potentiometer for regulating the soft-light feature, the setting for which

can range from the minimum thermal power to the maximum: