- ページ 9

アンプ Acom 1010のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Acom 1010 20 ページ。 External radio frequency power amplifier
Acom 1010 にも：回路図ドキュメント (14 ページ), 回路図 (15 ページ)

ページを印刷する

e) Preparation of the wall outlet for the amplifier.

If your amplifier is only fitted with one line (mains) fuse, it is suitable for the

European Community ONLY. Your dealer will check that your amplifier is

correctly fused before it is shipped to you, based upon your indicated location.

Customers should check with a qualified electrician if the amplifier is to be

used outside the country in which it was purchased.

Due to different line (mains) standards in different countries, the dealer will provide the correct Safety

Class I plug for your location. The ground lead of the power cable is colored yellow with two green

stripes. If you have any doubts about the correct way to connect these wires, consult your dealer.

Before connecting the amplifier to your line (mains) supply, be sure that the

line (mains) supply is correctly wired and is capable of providing the required

current, i.e., up to 5 A from 240 V and 10 A from 120 V. As discussed earlier,

it is very important that the ground lead is adequately sized and properly

connected.

The Power Switch on the front panel must be in the OFF position; only then should you insert the

amplifier's line (mains) plug into the appropriate wall outlet. At this time the amplifier remains switched

off.

3. POWER ON, CONTROLS AND INDICATORS

Do not turn the amplifier on for at least 2 hours after unpacking it and locating in its

operating location. Pay particular attention whenever the amplifier is moved from

a very cold place to a very warm one because unseen condensation may develop,

and this could result in damage to the high voltage circuits of the amplifier. Under

these circumstances, do not turn the amplifier on for at least 4 hours. A similar effect

could occur following rapid warming of the location, such as winter use of a powerful

electric heater.

To avoid damage that may not be covered by the amplifier warranty, carefully check

that the voltage for which the amplifier is set corresponds to your nominal line (mains)

voltage. See Section 2-2 and Table 2-1.

After following all instructions in Section 2, you may now turn ON the main power switch on the front

panel (Fig. 3-1). The green LED indicator above the switch will illuminate:

WARNING

CAUTION