- ページ 14

洗濯機 Whirlpool 8003437208836のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Whirlpool 8003437208836 20 ページ。

CLEANING THE WATER FILTER / DRAINING RESIDUAL WATER

Switch off and unplug the washing machine before cleaning the water filter or draining residual water . If you used a

hot wash programme, wait until the water has cooled down before draining any water .

Clean the water filter regularly, to avoid that the water cannot drain after the wash due to obstruction of the filter .

If the water cannot drain, the display indicates that the water filter may be clogged .

6 .

Remove the kick panel: Using a screwdriver, do that which

is shown in the following figure .

7 .

Container for the drained water:

Place a low and wide container under the water filter in

order to collect the residual water .

8 .

Drain the water:

Slowly turn the filter counter-clockwise until all the water

has come out . Allow the water to flow out without

removing the filter . Once the container is full, close the

water filter by turning it clockwise . Empty the container .

Repeat the procedure until all the water has been drained .

9 .

Remove filter: Lay a cotton cloth beneath the water filter,

which can absorb a small amount of rest water . Then

remove the water filter by turning it out anticlockwise .

10 .

Clean the water filter: remove residues in the filter and

clean it under running water .

11 .

Insert the water filter and reinstall the plinth: Reinsert the

water filter again by turning it in clockwise direction . Make

sure to turn it in as far as it goes; the filter handle must be in

vertical position . To test water tightness of the water filter, you

can pour about 1 liter of water into the detergent dispenser .

Then reinstall the plinth .

User manual