- ページ 4

冷蔵庫 Whirlpool WUR50X24HZのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool WUR50X24HZ 32 ページ。 Under counter refrigerator
Whirlpool WUR50X24HZ にも: 取扱説明書 (36 ページ), 取扱説明書 (36 ページ)

Whirlpool WUR50X24HZ 取扱説明書

Location Requirements

WARNING
Explosion Hazard
Keep ammable materials and vapors, such as
gasoline, away from refrigerator.
Failure to do so can result in death, explosion, or re.
To ensure proper ventilation for your Refrigerator, allow for
a 1/4" (6.35 mm) space on each side and at the top. When
installing your Refrigerator next to a fixed wall, leave 21/2" (6.35
cm) minimum clearance on the hinge side to allow for the door
to swing open.
NOTE: It is recommended that you do not install the
Refrigerator near an oven, radiator, or other heat source. Do not
install in a location where the temperature will fall below 55°F
(13°C). For best performance, do not block the base grille.
Opening Dimensions
Height dimensions are shown with the leveling legs
extended to the minimum height.
NOTE: When leveling legs are fully extended, add 5/8" (1.6
cm) to the height dimensions.
If the floor of the opening is not level with the kitchen floor,
shim the opening to make it level with the kitchen floor.
14 ¾"
(37.5 cm)
1/2"
(1.3 cm)
Critical dimensions:
A. 14.3/4" (37.5 cm) utility opening
B. 24" (60.96 cm) minimum opening width
4

INSTALLATION INSTRUCTIONS

1/4" (6.35 mm)
2 ½" (6.35 cm)
34 ³/ " (87.3 cm) min.
35" (88.9 cm) max.
A
24"
(60.96 cm) min.
B
24" (60.96 cm) min.

Electrical Requirements

WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Before you move your Refrigerator into its final location, it
is important to make sure you have the proper electrical
connection.
Recommended grounding method
A 115 Volt, 60 Hz., AC only, 15A or 20A fused, grounded
electrical supply is required. It is recommended that a separate
circuit serving only your Refrigerator be provided. Use an outlet
that cannot be turned off by a switch. Do not use an extension
cord.
NOTE: Before performing any type of installation, or cleaning,
unplug Refrigerator or disconnect power.
Unpack the Beverage Center
WARNING
Excessive Weight Hazard
Use two or more people to move and install
refrigerator.
Failure to do so can result in back or other injury.
Remove the Packaging
Remove tape and glue residue from surfaces before turning
on the Refrigerator. Rub a small amount of liquid dish soap
over the adhesive with your fingers.
Wipe with warm water and dry.
Do not use sharp instruments, rubbing alcohol, flammable
fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your Refrigerator. For
more information, see "Refrigerator Safety."
Dispose of/recycle all packaging materials.
When Moving Your Refrigerator
Your Beverage Center is heavy. When moving the
Refrigerator for cleaning or service, be sure to cover the floor
with cardboard or hardboard to avoid floor damage. Always
pull the Refrigerator straight out when moving it. Do not
wiggle or "walk" the Refrigerator when trying to move it, as
floor damage could occur. Having someone push against the
front top of the Refrigerator takes some weight off the front
leveling legs. This makes it easier to push the unit on the rear
rollers.