- ページ 20

ドライヤー Whirlpool 27'のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Whirlpool 27' 27 ページ。 Microwave oven and thermal oven
Whirlpool 27' にも：ジョブエイド (36 ページ), 取付説明書 (11 ページ), 取付説明書 (11 ページ), 取付説明書 (48 ページ), 取付説明書 (22 ページ), 取付説明書 (32 ページ), 取付説明書 (12 ページ), インストレーション・インストラクション (5 ページ)

CONNECT DRAIN HOSE

Proper connection of the drain hose protects your floors from

damage due to water leakage. To keep the drain hose from

coming off or leaking, it must be installed according to the

following instructions:

IMPORTANT: To ensure proper installation, this procedure

must be followed exactly.

Attach clamp to drain hose

Check the drain hose to see whether it is the proper length.

Wet the inside of the straight end of the drain hose with tap

water.

IMPORTANT: Do not use any lubricant other than water.

Squeeze ears of the silver double-wire clamp with pliers to

open. Place clamp over the straight end of the drain hose 1/4"

(6.4 mm) from the end.

Attach drain hose to drain connector

Open clamp. Twist hose back and forth while pushing onto

drain connector on the side of the washer/dryer. Continue until

hose contacts the ribbed stops on the cabinet. Place clamp

over the area marked "CLAMP." Release clamp.

¼"

(

)

6.4 mm

Place drain hose in standpipe

Drain

hose form

4.5"

(114 mm)

Place hose into standpipe (shown in picture) or over side of

laundry tub.

IMPORTANT: 4.5" (114 mm) of drain hose should be inside

standpipe; do not force excess hose into standpipe or lay on

bottom of laundry tub. Drain hose form must be used.

Remove drain hose form

(floor drain installations only)

For floor drain installations, you will need to remove the drain

hose form from the end of the drain hose. You may need

additional parts with separate directions. See "Tools and Parts."