- ページ 21

ドライヤー Whirlpool 27'のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Whirlpool 27' 27 ページ。 Microwave oven and thermal oven
Whirlpool 27' にも：ジョブエイド (36 ページ), 取付説明書 (11 ページ), 取付説明書 (11 ページ), 取付説明書 (48 ページ), 取付説明書 (22 ページ), 取付説明書 (32 ページ), 取付説明書 (12 ページ), インストレーション・インストラクション (5 ページ)

ページを印刷する

CONNECT INLET HOSES

Washer must be connected to water faucets with new inlet

hoses with flat washers (not provided). Do not use old hoses.

NOTE: Both hoses must be attached and have water flowing

to inlet valves. If you are only connecting to a cold water

faucet, you must use a Y-adapter (not included).

Insert washer into each hose

Washer

Insert a new flat washer into each end of the inlet hoses

(not provided). Firmly seat the washers in the couplings.

Connect inlet hoses to water faucets

Attach hose to hot water faucet. Screw on coupling by hand

until it is seated on washer. Use pliers to tighten couplings an

additional two-thirds turn. Repeat this step with second hose

for cold water faucet.

IMPORTANT: Do not overtighten or use tape or sealants on

valve when attaching to faucets or washer. Damage can result.

HELPFUL TIP: Make note of which hose is connected to hot

water to help in attaching hoses to washer correctly. In most

standard configurations, hoses will cross over each other

when attached correctly.

Coupling

Clear water lines

Run water for a few seconds through hoses into a laundry tub,

drainpipe, or bucket to prevent clogs. Water should run until clear.

Connect inlet hoses to washer

Attach hot water hose to the bottom inlet valve. Screw

coupling by hand until it is snug. Use pliers to tighten

couplings an additional two-thirds turn. Repeat with cold

water inlet valve (top valve).

IMPORTANT: To reduce risk of hose failure, replace the hoses

every 5 years. Record hose installation or replacement dates

for future reference.

Periodically inspect and replace hoses if bulges, kinks, cuts,

wear, or leaks are found.

Move washer/dryer to final location

Outer Access Panel

If you are working in a closet or recessed area: move the

washer/dryer into its final location and remove cardboard

from under washer/dryer. Remove the outer access panel by

removing 3 Phillips-head screws and one bumper, located at

the top of the access panel. Remove inner access panel by

removing clip, cover, and 2 screws. Set panels, screws,

clip, inner access panel cover, and bumper aside. Complete

hookup of water hoses and vent. Replace access panels upon

completion of washer/dryer installation.

Inner Access Panel