- ページ 8

ドライヤー Whirlpool 3LCED9100のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Whirlpool 3LCED9100 48 ページ。 Commercial he dryer
Whirlpool 3LCED9100 にも：取付説明書 (48 ページ), ユーザーマニュアル (5 ページ)

ページを印刷する

1. Maintenance Instructions

Electric

Shock Hazard

This is a 3-wire dryer which must be earthed.

Securely

tighten all electrical

connections.

Failure to do so can result in death, fire, or

electric

shock.

This dryer is supplied without an electric cord and plug;

it must be connected by a competent electrician.

See "Electrical Requirements".

1. Using a 102 mm (4") clamp, connect vent to exhaust outlet

in dryer. If connecting to existing vent, make sure the vent is

clean. The dryer vent must fit over the dryer exhaust outlet

and inside the exhaust hood. Make sure the vent is secured

to exhaust hood with a 102 mm (4") clamp.

2. Move dryer into final position. Do not crush or kink vent.

Make sure dryer is bevel.

1. With dryer in final position, place level on top of the dryer,

first side to side; then front to back. If the dryer is not level,

adjust the legs of the dryer up or down until the dryer is bevel.

2. Switch on power supply.

3. Check dryer operation:

Press the selection button for a full cycle and let the dryer run

for at least five minutes. Dryer will stop when time is used up.

NOTE: Dryer door must be closed for dryer to operate.

When door is open, dryer stops, but timer continues to run.

To restart dryer, close door and press a cycle button.

4. Start the dryer and allow it to complete a full cycle to make

sure it is working properly.

MAINTENANCE INSTRUCTIONS

Maintenance

instructions:

[] Clean lint screen after each cycle.

[] Removing accumulated

lint:

• From inside the dryer cabinet:

Lint should be removed every 2 years or more often,

depending on dryer usage. Cleaning should be done

by a qualified person.

• From the exhaust vent:

Lint should be removed every 2 years, or more often,

depending on dryer usage.

If dryer does not operate,

check the following:

[] Electric supply is connected.

[] Circuit breaker is not tripped or fuse is not blown.

[] Door is closed. Listen closely to hear door switch(es) activate.

[] Selected cycle button has been pressed firmly and display

shows cycle time.

ASSISTANCE OR SERVICE

For further assistance

If you need further assistance,

you can write or call with any questions or concerns at:

Whirlpool UK Ltd.

209 Purtey Way

Croydon

CR9 4RY

U.K.

Telephone: 0208 649 5000