Whirlpool 3LCED9100 설치 지침 매뉴얼 - 페이지 8
{카테고리_이름} Whirlpool 3LCED9100에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 3LCED9100 48 페이지. Commercial he dryer
Whirlpool 3LCED9100에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (48 페이지), 사용자 지침 (5 페이지)
페이지 인쇄
Electric
Shock Hazard
This is a 3-wire dryer which must be earthed.
Securely
tighten all electrical
connections.
Failure to do so can result in death, fire, or
electric
shock.
This dryer is supplied without an electric cord and plug;
it must be connected by a competent electrician.
See "Electrical Requirements".
1. Using a 102 mm (4") clamp, connect vent to exhaust outlet
in dryer. If connecting to existing vent, make sure the vent is
clean. The dryer vent must fit over the dryer exhaust outlet
and inside the exhaust hood. Make sure the vent is secured
to exhaust hood with a 102 mm (4") clamp.
2. Move dryer into final position. Do not crush or kink vent.
Make sure dryer is bevel.
1. With dryer in final position, place level on top of the dryer,
first side to side; then front to back. If the dryer is not level,
adjust the legs of the dryer up or down until the dryer is bevel.
2. Switch on power supply.
3. Check dryer operation:
Press the selection button for a full cycle and let the dryer run
for at least five minutes. Dryer will stop when time is used up.
NOTE: Dryer door must be closed for dryer to operate.
When door is open, dryer stops, but timer continues to run.
To restart dryer, close door and press a cycle button.
4. Start the dryer and allow it to complete a full cycle to make
sure it is working properly.
MAINTENANCE INSTRUCTIONS
Maintenance
instructions:
[] Clean lint screen after each cycle.
[] Removing accumulated
lint:
• From inside the dryer cabinet:
Lint should be removed every 2 years or more often,
depending on dryer usage. Cleaning should be done
by a qualified person.
• From the exhaust vent:
Lint should be removed every 2 years, or more often,
depending on dryer usage.
If dryer does not operate,
check the following:
[] Electric supply is connected.
[] Circuit breaker is not tripped or fuse is not blown.
[] Door is closed. Listen closely to hear door switch(es) activate.
[] Selected cycle button has been pressed firmly and display
shows cycle time.
ASSISTANCE OR SERVICE
For further assistance
If you need further assistance,
you can write or call with any questions or concerns at:
Whirlpool UK Ltd.
209 Purtey Way
Croydon
CR9 4RY
U.K.
Telephone: 0208 649 5000