- ページ 8
ドライヤー Whirlpool 8527813のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Whirlpool 8527813 13 ページ。 Commercial stacked dryer gas & electric
ページを印刷するPower supply cord
Use a new UL-approved power supply
cord rated 240-volt min., 30 amperes
and marked for use with a clothes
dryer.
WARNING
Fire Hazard
Use a new UL approved 30
ampere power supply cord.
Use a UL approved strain relief.
Disconnect power before making
electrical connections.
Connect neutral wire (white or
center wire) to center terminal
(silver).
Ground wire (green or bare wire)
must be connected to green
ground connector.
Connect remaining 2 supply
wires to remaining 2 terminals
(gold).
Securely tighten all electrical
connections.
Failure to do so can result in
death, fire, or electrical shock.
Page 8
Direct wire
WARNING
Fire Hazard
Use 10 gauge solid copper wire.
Use a UL approved strain relief.
Disconnect power before making
electrical connections.
Connect neutral wire (white or
center wire) to center terminal
(silver).
Ground wire (green or bare wire)
must be connected to green
ground connector.
Connect remaining 2 supply
wires to remaining 2 terminals
(gold).
Securely tighten all electrical
connections.
Failure to do so can result in
death, fire, or electrical shock.
1.
Disconnect the power supply.
external ground
conductor screw
tab
hold-
terminal
down
block
screw
cover
2.
Remove hold-down screw
and terminal block cover.
strain
relief
clamp
sections
3.
Assemble
3/4" U.L.-listed
strain relief (U.L. marking on strain relief)
into the hole below terminal block
opening. Tighten strain relief screws just
enough to hold the two clamp
sections together. Install power supply
cord/cable through the strain relief.
Complete installation following
instructions for your type of
connection:
• Four-wire (recommended method)
• Three-wire (if four-wire is not
available)
dryer
cabinet
strain relief
screws