ページを印刷する
- 1. Table of Contents
- 2. Safe Installation and Use
- 3. Intended Use
- 4. Installation
- 5. Description of the Dryer
- 6. Cleaning and Maintenance
- 7. Cleaning the Door Filter
- 8. Cleaning the Bottom Filter
- 9. Drainage System
- 10. Door Reversibility
- 11. Energy Saving
- 12. Troubleshooting Guide/After-Sales Service
- 13. Ec Declaration of Conformity
- 14. Disposal
For installing your dryer, you must observe the instructions of chapter SAFE INSTALLATION AND USE.
•
Carefully level the dryer by adjusting the four feet; check the correct leveling with a level.
•
Before running the first drying cycle, ensure that the water container is fully pushed inside and that
the bottom filter is correctly positioned (see chapter DESCRIPTION OF THE DRYER).
•
Also make sure that all hoses of the drainage system are connected as shown in the picture below.
If possible you can drain the water directly into the domestic plumbing system. This will avoid having to
empty the water container at the end of each drying cycle since the condensation water can be directly
drained away (see chapter DRAINAGE SYSTEM).
Electrical connection for Great Britain/Ireland
1) For Great Britain only
Warning – this appliance must be earthed
Fuse replacement
If the mains lead of this appliance is fitted with a BS 1 363A 13 amp
fused plug, to change a fuse in this type of plug use an A.S.T.A.
approved fuse to BS 1 362 type and proceed as follows:
1. Remove the fuse cover (A) and fuse (B).
2. Fit replacement 13A fuse into fuse cover.
3. Reinstall both into plug.
Important:
The fuse cover must be reinstalled when changing a fuse and if the
fuse cover is lost, plug must not be used until a correct replacement
is installed.
Correct replacements are identified by the color insert or the color embossed in words on the base of
the plug. Replacement fuse covers are available from your local electrical store.
8