- ページ 14

ドライヤー Whirlpool Cabrio,- WED7300XのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool Cabrio,- WED7300X 40 ページ。 Top-loading high efficiency low-water washer
Whirlpool Cabrio,- WED7300X にも： 取扱説明書 (40 ページ), 取扱説明書 (40 ページ), 取扱説明書 (36 ページ), 取扱説明書 (32 ページ), インストールマニュアル (16 ページ), 取扱説明書 (40 ページ), 寸法と設置について (1 ページ), 寸法マニュアル (2 ページ), 取扱説明書 (40 ページ), 取扱説明書 (48 ページ), 取扱説明書 (40 ページ), 取扱説明書 (40 ページ), 取扱説明書 (40 ページ), 取扱説明書 (44 ページ), 取扱説明書 (19 ページ), 使用とお手入れ グード (44 ページ), 取扱説明書 (44 ページ)

ページを印刷する
Whirlpool Cabrio,- WED7300X 取扱説明書
TROUBLESHOOTING
First try the solutions suggested here or visit our website at www.whirlpool.com/help
If you experience
Washer not performing as expected (cont.)
Washer won't run or fill,
washer stops working
14
for assistance and to possibly avoid a service call.
Possible Causes
Check for proper water supply.
Check proper electrical supply.
Normal washer operation.
Washer may be overloaded.
Not using HE detergent or using too
much HE detergent.
Both hoses must be attached and have water flowing to
inlet valve.
Both Hot and Cold water faucets must be turned on.
Check that inlet valve screens have not become clogged.
Check for any kinks in inlet hoses, which can restrict water flow.
Plug power cord into a grounded 3 prong outlet.
Do not use an extension cord.
Ensure there is power to outlet.
Reset a tripped circuit breaker. Replace any blown fuses.
NOTE: If problems continue, contact an electrician.
Lid must be closed for washer to run.
Washer will pause during certain phases of cycle.
Do not interrupt cycle.
Washer may be stopped to reduce suds.
Washer spins the load before filling to determine load size.
Remove several items, rearrange load evenly in basket and
add detergent. Close lid and press START/PAUSE.
Do not add more than 1 or 2 additional items after cycle has
started to avoid overloading or unbalancing.
Do not add more water to the washer.
Only use HE detergent. Suds from regular detergents can slow
or stop the washer. Always measure detergent and following
detergent directions based on your load requirements.
To remove suds, cancel cycle. Select DRAIN & SPIN. Select your
cycle. Press START. Do not add more detergent.
Solution