Whirlpool Cabrio,- WED7300X Руководство по эксплуатации и уходу - Страница 14

TROUBLESHOOTING

First try the solutions suggested here or visit our website at www.whirlpool.com/help

If you experience

Washer not performing as expected (cont.)

Washer won't run or fill,

washer stops working

for assistance and to possibly avoid a service call.

Possible Causes

Check for proper water supply.

Check proper electrical supply.

Normal washer operation.

Washer may be overloaded.

Not using HE detergent or using too

much HE detergent.

Both hoses must be attached and have water flowing to

inlet valve.

Both Hot and Cold water faucets must be turned on.

Check that inlet valve screens have not become clogged.

Check for any kinks in inlet hoses, which can restrict water flow.

Plug power cord into a grounded 3 prong outlet.

Do not use an extension cord.

Ensure there is power to outlet.

Reset a tripped circuit breaker. Replace any blown fuses.

NOTE: If problems continue, contact an electrician.

Lid must be closed for washer to run.

Washer will pause during certain phases of cycle.

Do not interrupt cycle.

Washer may be stopped to reduce suds.

Washer spins the load before filling to determine load size.

Remove several items, rearrange load evenly in basket and

add detergent. Close lid and press START/PAUSE.

Do not add more than 1 or 2 additional items after cycle has

started to avoid overloading or unbalancing.

Do not add more water to the washer.

Only use HE detergent. Suds from regular detergents can slow

or stop the washer. Always measure detergent and following

detergent directions based on your load requirements.

To remove suds, cancel cycle. Select DRAIN & SPIN. Select your

cycle. Press START. Do not add more detergent.

Solution