Washer Maintenance
r
WATER
iNLET HOSES
Replace inlet hoses after 5 years of use to reduce the risk
of hose failure. Periodically inspect and replace inlet hoses
if bulges, kinks, cuts, wear, or leaks are found.
When replacing your inlet hoses, mark the date of
replacement
on the label with a permanent marker.
NOTE: This washer does not include inlet hoses.
See the Installation Instructions for more information.
WASHER
CARE
Recommendations
to Help
Keep Your Washer
Clean
and Performing
at its Best
1. Always use High Efficiency (HE) detergents and follow the
HE detergent manufacturer's
instructions
regarding the
amount of HE detergent to use. Never use more than the
recommended
amount because that may increase the
rate at which detergent and soil residue accumulate
inside
your washer, which in turn may result in undesirable odor.
2. Use warm and hot wash water settings sometimes (not
exclusively cold water washes), because they do a better
job of controlling
the rate at which soils and detergent
accumulate.
3. Always leave the washer lid open between uses to
help dry out the washer and prevent the buildup of
odor-causing
residue.
Cleaning
Your Top Loading
Washer
Read these instructions
completely
before beginning the
routine cleaning processes recommended
below. This
Washer Maintenance
Procedure should be performed,
at a minimum, once per month or every 30 wash cycles,
whichever occurs sooner, to control the rate at which soils
and detergent may otherwise accumulate in your washer.
Cleaning the Inside of the Washer
To keep your washer odor-free, follow the usage instructions
provided above, and use this recommended
monthly
cleaning procedure:
Clean Washer Cycle
This washer has a special cycle that uses higher water
volumes in combination
with affresh ® Washer Cleaner
or liquid chlorine bleach to clean the inside of the washer.
Begin procedure
1. affresh ®Washer
Cleaner Cycle Procedure
(Recommended
for Best Performance):
a. Open the washer lid and remove any clothing or items.
b. Place an affresh ®Washer Cleaner tablet in the bottom
of the washer basket.
c. Do not place an affresh ® Washer Cleaner tablet
in the detergent dispenser.
d. Do not add any detergent or other chemical to the
washer when following this procedure.
e. Close the washer lid.
f. Select the CLEAN WASHER cycle.
g. Touch and hold the START/PAUSE
button to begin
the cycle. The Clean Washer Cycle Operation is
described below.
NOTE: For best results, do not interrupt cycle. If cycle
must be interrupted, touch POWER. After the Clean
Washer cycle has stopped, run a Rinse & Spin cycle to
rinse cleaner from washer.
F
WASHER
CARE (cont.)
"_
2. Chlorine Bleach Procedure (Alternative):
a. Open the washer lid and remove any clothing
or items.
b. Add 1 cup (236 mL) of liquid chlorine bleach
to the bleach compartment.
NOTE: Use of more liquid chlorine bleach than is
recommended
above could cause washer damage
over time.
c. Close the washer lid.
d. Do not add any detergent or other chemical
to the washer when following this procedure.
e. Select the CLEAN WASHER cycle.
f. Touch and hold the START/PAUSE
button to begin the
cycle. The Clean Washer Cycle Operation is described
below.
NOTE: For best results, do not interrupt cycle. If cycle
must be interrupted, touch POWER. After the Clean
Washer cycle has stopped, run a Rinse & Spin cycle to
rinse cleaner from washer.
Description
of Clean Washer Cycle Operation:
1. This cycle wilt fill to a water level higher than in normal
wash cycles to provide rinsing at a level above the water
line for normal wash cycle.
2. During this cycle, there will be some agitation and
spinning to increase the removal of soils.
After this cycle is complete, leave the lid open to allow
for better ventilation and drying of the washer interior.
Cleaning
the Outside
of the Washer
Use a soft, damp cloth or sponge to wipe away any spills.
Use only mild soaps or cleaners when cleaning external
washer surfaces.
IMPORTANT:
To avoid damaging the washer's finish, do not
use abrasive products.
13
ページを印刷する